Specifications
Case - Drawn steel 7-3/4" (19.7 cm) high, 5" (12.7 cm) wide, 3"
(7.6 cm) deep in gray finish. Spring hasp, with hole for lock, holds
permanently attached, side hinged door closed. Three mounting holes
on back plus handy box mounting holes. EP Models in plastic beige
NEMA 3R raintight enclosure; 9'/«" (23.8cm)H, 51/;" (14.0cm)W,
y/<" (9.5cm)D. Note: The electronic mechanism snaps into the standard
Intermatic time switch case, replacing mechanical mechs, if desired.
Knockouts - Combination l/2"-3/4" nominal knockouts, one on back
and each side of case and two on bottom.
Optional Enclosures - See page 60 for optional enclosures. Refer to
price list (TS190) or contact factory for availability of time switch
in other enclosures.
Special Voltages and Cycles - ALL models 50 or 60 Hz.
Switch Rating - Except model ET100C.
Each Pole for DPST models.
30 amp inductive/resistive, 24 / 120 / 240 / 277 volts A.C. 60 Hz.
20 amp resistive, 28 V.D.C.; 1 H.P. 120 volts A.C. 60 Hz.
2 H.P. 240 volts A.C. 60 Hz.
5 amp tungsten, 120 / 240 / volts A.C. 60 Hz:
20 amp ballast, 120-277 volts.A.C. 60 Hz.
ET100C same ratings for 120 volt loads only.
Models - ET105C and ET175C the normally closed contact ratings are
as follows: 10A resistive/general purpose, 12 - 277VAC